Perla Industrial Primer

Surfaces should be cleaned of old paint film, oil, dust, dirt, moist, chloride, sulphate salts, rust, rolled mud, tempering, casting - welding burrs etc. which will reduce adhesion on the application surface . Metal surfaces must be sanded at minimum Sa2 ½ (ISO 8501-1, SSPC-SP10) (sand blasting), prime the sanded surface with Perla Industrial Primer in 6 hours. Apply after mixing the thinned product according to the application equipment thoroughly until it becomes homogenous. After the primer has fully dried (in 4 to 6 hours), the finishing coat paint can be applied. The surface temperature must be minimum 3 Celsius degrees higher than the dew temperature. Application at temperatures near the dew point is not recommended. For the topcoat application wait for 24 hours between coats. Application Temperature: Min. +10°C/ Max. + 30°C

One component / Polisel Cellulosic & Poli HRM thinner 15 - 20%

5-6 m²/L or 3-4m²/kg (60 - -80 µ DFT)

Touch dry in 20-30 minutes and hard dry in 24 hours.

Air - airless spray

15 kg - 24 kg