Two component, reaction dried, coal-tar containing, high solid coating, hardened with epoxy resin-based polyamide hardener, used for priming surfaces where high corrosion resistance is required. Can be applied on metal surfaces exposed to water, seawater, chemicals and wearing.
Surfaces should be cleaned of old paint film, oil, dust, dirt, moist, chloride, sulphate salts, rust, rolled mud, tempering, casting - welding burrs etc. which will reduce adhesion on the application surface. Metal surfaces must be sanded at minimum Sa2 ½ (ISO 8501-1, SSPC-SP10) (sand blasting), prime the sanded surface with Epoxy Anticorrosive Primer or Polyurethane Anticorrosive Primer in 6 hours. Epoxy Coal Tar can be applied after the primer has hard dried (in 4 to 6 hours). Epoxy Coal Tar can be used as a primer on its own. Mix the paint and the hardener in the given ratio until a homogeneous mixture is obtained. Rest the mixture for 2 to 3 minutes for preliminary reaction and apply with the recommended apparatuses. The surface temperature must be minimum 3 Celsius degrees higher than the dew temperature. Do not apply near dew point or on wet, damp surfaces. For the topcoat application wait for 24 hours between coats. Application Temperature: Min. +10°C / Max. + 30°C